PHASE INVERTER
Model INV10
GENERAL PURPOSE PHASE INVERTER
VOLTAGE
FIXED GAIN
BROADBAND
±10 V
-1 X
DC to 5 MHz
GENERAL DESCRIPTION
The INV10 is a general purpose, low voltage phase inverter designed for laboratory use. It is based on broadband operational amplifiers with a feedback network chosen to give a voltage amplification of -1. Any function or arbitrary waveform generator with low output impedance and output voltage up to ±10 V can be used as an input device.
INPUT AMPLITUDE
The input amplitude should normally be kept within ±10 V and not exceed ±12 V. This is most important since the input protection network will limit the signal amplitude and cause distortion. The input protection network effectively cuts accidental spikes and overshoots. It is equipped with a fuse rated at 15 mA, which will be blown if the input voltage exceeds 500% of the maximum.
LOAD
The amplifier is intended to be used as a signal source for devices with high input impedance. Maximum output current is 50 mA.
FREQUENCY RESPONSE
SUMMARY OF TECHNICAL DATA
Bandwidth:
DC to ca 5 MHz
Amplification:
-1 times, fixed
Load: type
resistive || capacitive
Impedance: input
output
1 MΩ || 30 pF
10 Ω
Voltage: input
nominal ±10 V
Current: output
max 50 mA
Input protection fuse:
15 mA (Littelfuse, part number 273.015) one spare fuse provided inside the instrument, additional fuses available from FLC Electronics AB.
Operating Ambient Temperature:
0°C to 30°C
Storage Temperature:
0°C to 60°C
Relative Humidity:
up to 90% (operation) 30% to 50% (storage)
Power Requirements:
either 100/110 V or 220/230 V, 50/60 Hz (factory set)
Fuse:
100/110 V: 2x 630 mA (slow), 220/230 V: 2x 315 mA (slow)
Dimensions (H/W/L):
105 x 60 x 210 (mm)
Weight:
1.4 kg
Country of Origin:
Sweden
Note: Specifications apply to instruments operating at 23°C±5°C ambient temperature after 5 min warm-up time. Due to ongoing product development, specifications are subject to change without notice.
商品属性 [频率] DC to 5 MHz